photo gallery
Panel Upgrades
Electrical Panels need to be upgraded for a variety of reasons. These include corrosion, sparking, or increased electrical demand, to name a few
Flush mounted main panel replacement
A new flush mounted main panel replacing an obsolete Zynsco type panel
Flush mounted service panel
We trim around the panel to maintain wall integrity and water tightness
Flush mounted in stucco wall
Flush mounted in stucco wall
Energy Storage Systems (ESS)
Battery Backups, coupled with a roof top solar array, allow continuous power during outages. It also allows homeowners to sell back to the grid during peak hours
A 40 kwh system for a full house backup
This system is big enough to run everything including a large AC unit during power outages
A 13 kwh ess for a partial backup
All the essential circuits have been relocated to an Essential Load Center that is kept live during outages
a 20 kwh backup
This whole house Energy Storage backup is coupled with a generator as a secondary backup for longer outages during storms where the PV might not charge as much
Electrical Wiring
From new construction to remodels to panel changes, we run wires as if they'll be on display! The clean work is not just for show either as sloppy work can result in electrical mishaps
New construction
Clean wire runs along building lines even if it will all be hidden behind sheetrock
new sub-panel
All circuits terminate in an electrical panel. Each circuit is properly grounded and labeled
service panel
All circuits get identified so the breakers can be labeled correctly
Add a footnote if this applies to your business
additional Photos
BEFORE:
An old, crowded setup with rusty components.
AFTER:
Newly installed panel,
Clean, labeled and to code.
BEFORE:
An old and unsafe Zinsco panel about to be replaced.
AFTER:
The new panel complete with an interlock system for a generator backup and a future solar disconnect.
BEFORE:
Another old Zinsco panel that needs to be replaced.
AFTER:
The new replacement panel installed.
Show More